TRANE XR202 INSTALLATION AND USER MANUAL Pdf Download (2024)

FAQs

How do I get to the installer settings on my Trane thermostat? ›

From the Home Screen, press Menu. Press Next repeatedly until Service is displayed. 2. Press and hold Select until Installer Settings is displayed.

Turn Wireless 'Off' and 'On' again: On the thermostat main screen, go to Menu→Settings→Network→Wireless, then “ON/OFF” Reboot Thermostat: If the thermostat does not connect after turning the wireless off and on, try rebooting the thermostat.

The default password for entry at the panel: + Button / - Button / Set Time button / Set Date button. If this does not work, contact your local Trane office.

The thermostat may have a dead battery, so replace them with fresh ones and try again. Your furnace may turn on right away after this. If it doesn't, you may have a faulty power circuit. Have an HVAC professional diagnose this issue, and provide you with professional recommendations.

Changing Period Set Points

1. Select the active Period's Cooling or Heating Set Point. 2. Adjust the Set Point using the UP or DOWN arrows.

Although thermostats can be adjusted manually, programmable thermostats will avoid any discomfort by returning temperatures to normal before you wake or return home. Avoid setting your thermostat at a colder setting than normal when you turn on your air conditioner.

The auto setting on your thermostat tells your HVAC system to only run with it's necessary. It automatically turns on when the home starts to fall below the desired temperature. Ultimately, you don't waste energy having the fan push air through your home all day and night.

Try checking the circuit breaker box or replacing the batteries. Bad wiring: The thermostat may be unresponsive if the wiring has gone bad. Remove the cover and check inside for loose, detached, or corroded wires. If you spot any problems, contact an HVAC technician for assistance.

Why is my thermostat not pairing? ›

Your Thermostat Is Off or Needs New Batteries

So, be sure to double-check that your thermostat is on and appears to be functioning as normal. Even if everything looks good on the surface, another DIY step worth taking is to replace your thermostat's batteries.

Turn your thermostat “off”, then flip the related circuit breaker “off”. Wait 30 seconds, then turn the breaker back “on,” then the thermostat. Set the thermostat to hot or cold, whichever you prefer, and your desired temperature. This should effectively reset it.

Press and hold the 'Menu' key for five seconds, and 'ISU' will populate. Then press the 'Select' button. Was this article helpful? Thanks for your feedback!

When a thermostat is in recovery mode, this simply means it is recovering from being in an energy-saving mode. During recovery mode, your thermostat is working toward achieving a newer temperature that is cooler or warmer than the outside air.